Top Railway Spikes Manufacturer-GNEE
How to install railway spikes
Bolt spikes are a common railway turnout accessory that are often seen on railways. The role of bolt spikes is also very important. In fact, there are many types of road spikes. In addition to bolted road spikes, there are other types. If divided according to material, road spikes can be divided into cast aluminum spikes, plastic spikes, ceramic spikes, glass spikes, reflective spikes, etc. Different types of road studs have different characteristics and can be used in different situations.
1. Place and install safety isolation facilities. This is a very important point. I hope everyone cannot ignore it. During the entire dynamic construction process, whether it is a new road or a road that has been opened to traffic, everyone should be in the safety facilities. If the construction is on a road open to traffic, the ratio of safety personnel to installation personnel should be 1:1. For construction on non-traffic sections, the ratio of safety personnel to installation personnel should be 1:3.
2. Determine the installation location and ensure that the installation location is flat. For pavement with expansion, cracks and unevenness, the pavement must be smoothed in advance.
3. Clean the installation location with a brush and make sure the installation location is dry. Take an appropriate amount of glue and apply it evenly on the road studs.
4. Press the road spike tightly on the installation position and ensure that the direction is correct. If there is too much glue, be sure to clean it; if it is a cast aluminum footed road spike, make sure that the hole depth is 1cm greater than the nail foot depth and the hole diameter 2mm larger than the nail foot diameter.
5. An inspection should be conducted within two hours after the road studs are installed to ensure that all road studs are not installed backwards, crooked or crooked. After the road studs have cured for 4 hours, remove and install the isolation facilities.
Railway spikes are divided into two types: manual spikes and mechanical spikes. It is hand-made and has various appearance and dimensions, but the price is low and is generally shipped by the ton. Mechanical nails are made by machines through forging, heat treatment, wire sleeves and other processes. In addition, by interpreting the above information, you can also clearly understand that installing road studs is not a complicated matter, but it requires attention to many details. And this information will directly affect the application effect and service life of the road stud.
